![]() I've never had any problems with this configuration. I can flip the modem into Bridge mode, or Gateway mode at any time and the router keeps on running without any issue. This gives me access to the modem from behind the router by using 192.168.100.1 as the modem's log in page. Anything behind the router can't be seen from the modem side of the router. What this results in is a walled off network within a network. This is the configuration that I use as I'm too lazy to configure the router as an access point every time that I'm running any tests on the modem. With those parameters set, reboot the router. The private IP Address Ranges are as follows: I use 10.0.0.1 as the router's IP address for example, and keep the IP address range to a minimum, running from 10.0.0.2 to 10.0.0.30 This is to avoid any conflicts with the modems IP address or IP address range. To do that you have to set the Router's IP address and IP address range to something else in the private address range. You can run the router in full Router Mode, with its own firewall and DHCP server running. You also have to turn off the router's firewall and DHCP server.Įither way, the modem is in control of the network in terms of the IP addresses.Ģ. You can do this manually as well by disconnecting the modem cable from the WAN port and connecting it to any of the router's LAN ports. The router is still connected via the Router's WAN port. It should turn off the router firewall and DHCP server. You can do that via the Router's Operating Mode selection, selecting Access Point mode instead of Router Mode. So, essentially what that means is turning the router into an Access point. Ensure that there is only one DHCP server on the network, which in this case should be the modem. The tech is correct, you don't have to run the modem in Bridge mode, but, you do have to do one of two things if you want to keep running the modem in Gateway mode:ġ. Ok, you might have a DHCP conflict going on with your present configuration.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |